Bently Nevada 330104-01-05-50-02-00 performs the sensing stage of the matched 3300 XL 8 mm proximity chain. Its probe tip, integral cable and ClickLoc termination carry one continuous eddy-current response from the conductive target to the Proximitor Sensor.

1. 01

   Eddy-current sensing

   The 8 mm tip of Bently Nevada 330104-01-05-50-02-00 establishes a non-contact electromagnetic field at the conductive target. A change in shaft-to-tip distance changes the coil impedance, providing the raw gap response used by the matched electronics.

2. 02

   Static and dynamic response

   Target movement changes the response carried by Bently Nevada 330104-01-05-50-02-00 through its integral 5.0 m cable. The same signal path represents static gap and dynamic shaft motion within the complete system’s 2 mm linear range.

3. 03

   Proximitor handoff

   The ClickLoc end of Bently Nevada 330104-01-05-50-02-00 connects to the matched five-metre Proximitor Sensor. That electronics stage converts the probe response to the nominal 7.87 V/mm voltage scale used by the receiving monitor.

The encoded case dimensions, thread and armored cable determine how Bently Nevada 330104-01-05-50-02-00 fits and routes in the machine. These mechanical limits preserve the target geometry and the electrical length of the matched transducer chain.

1. 01

   Mounting envelope

   The 10 mm unthreaded end and 50 mm case define the insertion geometry of Bently Nevada 330104-01-05-50-02-00. The probe is positioned so the active tip faces the conductive target without exceeding the available thread engagement.

2. 02

   Thread and gap control

   Bently Nevada 330104-01-05-50-02-00 uses an M10 × 1 thread with 15 mm maximum engagement and 11.2 N·m recommended mounting torque. A radial-vibration installation is set near the recommended 1.27 mm gap inside the usable linear range.

3. 03

   Armored cable route

   The 5.0 m lead of Bently Nevada 330104-01-05-50-02-00 is protected by flexible stainless-steel armor. The route remains above the 25.4 mm minimum bend radius and finishes at a clean, fully seated ClickLoc connector.