GE IC695GCG001 PACSystems RX3i Genius Communication Gateway
Product Description
IC695GCG001 bridges an RX3i PROFINET network to a Genius I/O bus. It lets a PROFINET controller exchange data with installed Genius devices while preserving the field-bus addressing and scan relationships.
On the controller side it appears as a PROFINET device; on the field side it maintains one Genius bus. A successful changeover must preserve the PROFINET name and module layout as well as Genius address, baud rate, termination and device order.
Technical Specifications
Genius-to-PROFINET Data Boundary
Field side
Retain Genius serial-bus address, baud rate, termination and device order.
Controller side
Preserve PROFINET device name, IP settings and module layout expected by the PNC.
Data mapping
Verify byte order, status data and fault behavior instead of assuming identical point positions.
Gateway Cutover Sequence
Export
Export the hardware configuration and record every Genius device address.
Verify
Verify bus termination, shield continuity and external 24 VDC polarity.
Commission
Commission the PROFINET device first, then prove Genius I/O and redundancy behavior channel by channel.
FAQ
Which order-code checks belong to the Genius-to-PROFINET Data Boundary decision for IC695GCG001?
Match the complete order code, hardware revision, hand-held monitor and installed system configuration; a similar family name is not enough for replacement selection.
What must be backed up before the Gateway Cutover Sequence procedure for IC695GCG001?
Save the editable application, hardware configuration, communication parameters, retained production data and the firmware or software baseline used by this PACSystems RX3i Genius Communication Gateway.
How does field side affect Genius-to-PROFINET Data Boundary for IC695GCG001?
Retain Genius serial-bus address, baud rate, termination and device order.
Why does controller side need separate verification during Gateway Cutover Sequence for IC695GCG001?
Preserve PROFINET device name, IP settings and module layout expected by the PNC.
How should IC695GCG001 complete the Gateway Cutover Sequence sequence before return to service?
Complete the documented startup sequence, verify diagnostics and communications, test the application under controlled conditions and confirm the applicable machine interlocks.
For quotation preparation, buyers can provide the full model number, quantity and destination for each requested component.
Moore Automation organizes the mixed product list for commercial review, packing requirements and shipment planning.
No related record found